What would happen if the SAT4D were to experience something like 20 alarms in a day? Would it continue to communicate all those alarms with the Sensaphone server or would it stop? That’s not a problem. We have had devices do this before and there have been no issues and there are no additional charges [...]
1. Double Check that the antenna is installed in the right location. This is a common cause of intermittent problems.
Most Sensaphone models are designed to call when the power is interrupted only, but you can simply add a FGD0054 to any spare input to have it call you when the power is restored.
Here are some suggestions to determine if your Drive-Alert System requires service. Most problems can be readily isolated. Intermittent, constant alarm When an intermittent or constant alarm occurs, disconnect the plug from the 120-volt power. Open the door to models DA-503 or DA-504 and disconnect the red and black sensor wires from the terminal strip. [...]
With the Sensaphones 400 and 800 once the alarm is acknowledged it won’t alarm/call again unless the alarm is reset. With the Sensaphone 1400 and 1800 that is also true by default BUT there is a reset timer that may be used that will have the dialer keep calling if the alarm is not fixed [...]
After putting batteries in the intercoms, find the “Learn” button on them. Look at the pictures below to see where they are on the two available intercom styles. Clear the memory on all intercoms. You do that by holding down the Learn button until you hear a beep and then continue holding until you hear [...]