This is really handy if you want your chime to make distinct tones based on the sensor which is activated, yet still have every sensor activate the accessory (I.e. siren, strobe etc.) which you have connected. Please Note: In the below diagram the black wire identifies the negative lead from power supply. You will need […]
Yes you can. The intercoms have four different channels they can be set to as well as a “paging” channel. Each intercom is capable of communicating with only other intercoms which are on the same channel as well as communicating on the “paging” channel regardless of the private channel the intercom is set to.
Simply turn the unit off, than back on while holding down the Button labelled 1.
This could be a few things, however the most common reason we are currently experiencing is that the SIM Card is for a different type of network than 3G (which is the only network the Telular SX6TEs are designed for use on). To check this take a look at the SIM Card you are using […]
If you are using ELKRP2 Software you can have automatically check and download the updated firmware. When you are connected to your M1 system if you go to: “Send/Rcv” in the top menu of RP2 than click: “Enroll/Update Device” in that menu it will bring up a list of the devices which are enrolled in […]
My MURS M538HT Radio is experiencing above average static and reads RX in the read out when the static is happening. How can I fix this?
One thing that could be happening with this unit is that it is picking up interference from another MURS unit in the area. This particular unit could be a little more sensitive than the other units and is picking up the carrier on a signal that is to weak to receive the full transmission. To […]
If the TxID Label is missing you can manually Learn in the sensor through Keypad Programming then use the ElkRP Software to “Receive Wireless Setup” which will retrieve the TxID numbers for all the wireless sensors. Please see the ELK-6022 Installation Manual for instructions on Manually Learning a sensor.