• Home
  • USA Store
  • Canada Store
  • New Ticket
Absolute Automation Knowledgebase
  • Home
  • USA Store
  • Canada Store
  • New Ticket

Category: STI

/Door Alarms / STI /

I’m testing my STI System and it doesn’t seem to be consistent. What can I do?

The STI Sensors have a reset time built into them to avoid multiple alarms back to back. If you are testing the unit and the sensor is open you should be able to hear it “ticking” during and after each activation. The sensor will not send another alarm signal until this ticking done.

Read More →

Troubleshooting my STI Alarm System

1. Double Check that the antenna is installed in the right location. This is a common cause of intermittent problems.

Read More →

Recent Support Articles

  • Alarm.com Self Monitoring
  • WS4945 DSC alarm sensor not working with Dakota Alert DCR-2500
  • How do I set the Channel and Sub Channel on my MURS radio?
  • How do I set the Channel and Sub-Channel on my MURS MAPS transmitter?
  • My DCMA-2500 is false alarming. How can I fix this?

Tags

bba-2500 bba2500 chamberlain cookstop da500 dakota dakota alert dakota alert 3000 dcma dcma-2500 door switch dual thermostat fa1 fa700 fai false alarms fgd400 freeze alarm freeze alarm intermediate incoming ring count klick it locations m538bs mier murs murs channel NIST optex power outage probe sensaphone sensaphone 400 splice spot protect spotprotect thermostat UAD uad 300 uncle albert water alarm dialer water sensors wifi wire wmt wmt 3000