My Sensaphone 400 is locked out and will not let me enter commands, how can I fix this?

/Alarms and Monitors / Sensaphone / My Sensaphone 400 is locked out and will not let me enter commands, how can I fix this?

October 28, 2013
Sensaphone

If the LED is blinking the unit is in StandBy mode. To open the unit up to receive commands again simply press the – RUN/STANDBY – key to take the unit out of StandBy mode.

How to change your Sensaphone 400 and 800 from Metric to Imperial
How too adjust voice repetitions in the FGD-0400.
Are there any monitoring fees with your alarm products?
What is my Sensaphone AutoDialer Acknowledgement code?
I have a small greenhouse operation and I’d like to know if the temperature gets too high or too low. What should I use?
My Sensaphone 400 constantly reads 150F (65 C), what’s wrong?

Recent Support Articles

Alarm.com Self Monitoring
WS4945 DSC alarm sensor not working with Dakota Alert DCR-2500
How do I set the Channel and Sub Channel on my MURS radio?
How do I set the Channel and Sub-Channel on my MURS MAPS transmitter?
My DCMA-2500 is false alarming. How can I fix this?

Related Articles

How to change your Sensaphone 400 and 800 from Metric to Imperial

How too adjust voice repetitions in the FGD-0400.

Are there any monitoring fees with your alarm products?

What is my Sensaphone AutoDialer Acknowledgement code?

I have a small greenhouse operation and I’d like to know if the temperature gets too high or too low. What should I use?

My Sensaphone 400 constantly reads 150F (65 C), what’s wrong?

Recent Support Articles

Tags